Driver Side - Mack Granite GU Series Operator's Handbook Manual

46 SAFETY INFORMATION

Driver Side

The following cab entry and exit procedures, along with the safety guidelines
outlined in Three-Limb Contact earlier in this section, should be used with
this MACK vehicle.
Entry
These entry procedures are illustrated on the following page:
1 With both feet firmly on the ground, grab the outside handhold with both hands
or grab the outside handhold with one hand and grab the steering wheel or inside
handhold (if equipped) with the other hand. Then raise one foot to the bottom
step. (See figure 1.)
2 Maintain a firm grip on the handholds and/or steering wheel and raise your other
foot to the top step. (See figure 2.)
3 While still gripping the handholds and/or steering wheel, raise one foot to the
cab floor. (See figure 3.)
4 Move one hand at a time to the steering wheel, inside handhold (if equipped) or
cab interior. Bring the other foot inside the cab and sit down. (See figure 4.)
Exit
To exit, follow the illustrations in reverse order:
1 With both hands gripping the steering wheel, inside handhold (if equipped) or
cab interior, stand up and face the inside of the cab. Move one foot to the top
step. (See figure 4.)
2 Move one hand to the outside handhold and grip the steering wheel, inside
handhold (if equipped), or cab interior with the other hand. With one foot firmly on
the top step, lower the other foot to the bottom step. (See figure 3.)
3 Maintain a firm grip on the handholds and/or steering wheel, and keep one foot
firmly on the bottom step. Then lower the other foot to the ground. (See figure 2.)
4 With both hands firmly gripping the handholds and/or steering wheel, lower the
other foot to the ground. (See figure 1.)