Festo CPV GE-ASI-8E6A-Z Series Brief Description page 17

3 Installation instructions
3.1 AS−Interface Addresses
Before connecting to the AS−Interface bus: assign an un
used address to each slave.
Please note
The valve terminal type CPV..−GE−ASI−8E8A−Z contains
2 AS−Interface slaves. The valve terminal behaves on
the AS−Interface bus like two individual valve ter
minals each with 4 inputs and 3 outputs (valve sole
noid coils).
Assignment of the inputs and outputs (valves):
Slave 1: Inputs I0...I3; outputs O0...O2
Slave 2: Inputs I4...I7; outputs O4...O6.
Automatic addressing with the function Automatic
address assignment" of the master is not possible.
It is not necessary to parametrize the AS−Interface
slave.
Address assignment
The assignment of the data bits to the inputs and outputs
of the slave shows the following figure:
Data bits:
Inputs:
Outputs:
E/A = bi directional (B)
The address mapping depends on the configuration of the
master.
Festo CPV..−GE−ASI−8E6A−Z 0305NH English
Slave 1: IO code 7
D0 D1 D2 D3
I/O I/O I/O I/O
I0 I1 I2
O0 O1 O2
Slave 2: IO code 7
H
D0 D1
I/O I/O
I3 I4 I5
O4 O5
H
D2 D3
I/O I/O
I6 I7
O6
17