English - Festo CPV GE-ASI-8E6A-Z Series Brief Description

1 User
Valve terminal type CPV..−GE−ASI−8E6A−Z has been de
signed exclusively for controlling pneumatic actuators and
is intended for use in bus systems in accordance with the
AS−Interface specification 2.1. If additional commercially−
available components such as sensors and actuators are
connected, the specifiedlimits for pressures, tempera
tures, electrical data, torques, etc. must not be exceeded.
AS−Interface bus systems and valve terminals may only be
installed by personnel especially trained for this purpose.
Detailed information on the design and addressing of your
bus system can be found in the manual for your AS−Inter
face master.
Information on the pneumatic components of the valve ter
minal can be found in the Pneumatics manual P.BE−CPV−... .
Warning
S Switch off the power supply before connecting or
disconnecting plugs (otherwise this could lead to
functional damage).
S Connect one of the earth connections on the end
plates with low impedance (short cable with large
cross−sectional area) to the earth potential.
S Commission only a valve terminal which has been
fitted and wired completely.
If to be used as an explosion−protected operating de
vice, make sure that:
S electrical contacts are not disconnected under tension
S the completely fitted valve terminal with all plugs,
adapters and protective caps complies at least with
protection class IP 64.
Festo CPV..−GE−ASI−8E6A−Z 0305NH English
instructionsEnglish
15