Printing The Last Co Report; Deleting The Last Co Report; To Print All Co Reports - Extech Instruments CO80 Manual

saved and can also be printed at a latter time. To print the previous
results, refer to 4.6.3.
Refer to 4.7.3 to switch off the CO80 during CO room test.
5.5.3

Printing the Last CO Report

ress the "Log" key activate the "Save/Print/Send" menu. Press
P
"Scroll" until the "Print" flashes. Press and hold "Log" until a beep is
heard – the last activated report should now be transmitted via the IR port
and the information display on the screen.
During the CO room test, the CO80 cannot be used for combustion
analysis (displays 1 and 2), as these could severely alter the CO readings
and render them useless.
5.5.4

Deleting the Last CO Report

To delete the last report or current report if a log is in progress, whilst in
the CO display screen , press the "Log" key, followed by the "Scroll" key
so that the "Save" icon is flashing.
Press the "Pressure" key so "del" flashes on the bottom line. To delete
the last CO log press and hold the "Log" key whilst "del" is flashing.
To cancel the delete log request, either press the "Pressure" key followed
by "Scroll" or "Light" key to select the next logging function.
5.5.5

To Print all CO reports

Whilst in the CO menu and whilst there is no current CO room
measurement running, press "Log" and "Scroll" twice until the "Send"
icon flashes. Press and hold "Log" until a beep is heard and 25 reports
shall be printed.
Sending all saved sets of readings when in HP mode, will result in all 25
memory locations printing out, which will take up to one hour.
WARNING
WARNING
35 CO80 V3.1 04/06