Siemens SIMATIC IM 151/CPU Manual page 125

5b
6 Confirm the settings with OK, and close the Setting the PG/PC Interface program.
7 Open the front panel of the S7-300 CPU.
Remove the connector of the programming device cable from the MPI interface of the S7-300
CPU, and put it on the bus connector of the PROFIBUS-DP cable on the S7-300 CPU. Secure
the connector.
Close the front panel of the S7-300 CPU as far as possible.
8 Navigate in SIMATIC Manager to the block container
of the ET 200S.
Select the block container in the left-hand part of the
window.
In SIMATIC Manager, choose the 'RZQORDG
command from the 3/& menu to transfer the
program and the hardware configuration to the
IM 151/CPU.
Click <HV in all the dialog boxes that appear.
9 Put the mode selector of the IM 151/CPU into the
5813
position
10 Put the mode selector of the S7-300 CPU into the
5813
position
Getting Started - ET 200S-IM 151/CPU Interface Module
A5E00058783-01


*HWWLQJ 6WDUWHG
The program and configuration are
downloaded from the programming
device to the CPU.
6723
The LED of the IM goes out.
581
The LED starts to flash and then
comes on continuously. The 6) LED
comes on.
6723
The LED of the S7 goes out.
581
The LED starts to flash and then
comes on continuously. The 6) LED of
the IM goes out.
8-17