FLIR FB Series Installation And User Manual page 48

Advanced Configuration
The illustration at the right shows the default settings for
the output signal channel, Input/Output 2.
• The Label setting can be changed to reflect more
specific alarm information which can then appear in
VMS systems such as FLIR Latitude.
• The GPIO Name determines the circuit point for the
GPIO driver and must not be changed. Set an Initial
Value (On or Off) for this output signal.
The Output Reset Interval is used to automatically
•
reset the output signal after a set time. Setting the
value to 0 prevents the output from resetting
automatically after a timeout. See also the Alarm
Manager GPIO Output State Mode parameter,
Output from Motion Alarm, pg.
• Set Alarm Output GPIO Logic to Positive for a
normally open switch signal (circuit closes for
alarm), Set GPIO Logic to Negative for a normally
closed switch signal (circuit opens for alarm).
Click on the Save button to save any changed settings. The changes will not take effect until the
server is stopped and started.
Refer to the following sections for a description of how to combine the GPIO inputs and outputs with
other alarms. For example, the camera can send the output signal when there is a Video Analytics
alarm. Similarly, the camera can save an image snapshot when there is an input. These associations
are configured with the Alarm Manager module described in
Modules Menu
This section describes the Alarm Manager page. Use the Alarm Manager page to define rules for
camera alarms from Video Analytics or GPIO.
Alarm Manager: Use the Alarm Manager page to set the response (action) that results from an
individual alarm. It is possible to have more than one action for a single alarm by adding additional
rules (for example, one action could capture an image and another could generate an output). If a
427-1065-00-12 Revision 130
GPIO
52.
November 2019
This document does not contain any export-controlled information.
Alarm Manager, pg. 48.
48