Chapter 4: Maintenance; Service And Inspection Schedule; Cleaning And Lubrication - Aerotech ARMS Series Hardware Manual

ARMS Hardware Manual

Chapter 4: Maintenance

The ARMS series stages are designed to require minimum maintenance.
D A N G E R : To minimize the possibility of bodily injury or death, disconnect all electrical
power prior to performing any maintenance or making adjustments to the equipment.

4.1. Service and Inspection Schedule

Inspect the ARMS at least once per month. A longer or shorter inspection interval may be required depending
on the specific application, and conditions such as the duty cycle, speed, and environment.
Monthly inspections should include but not be limited to:
Visually inspect the stage and cables.
l
Re-tighten loose connectors.
l
Replace or repair damaged cables.
l
Clean the ARMS and any components and cables as needed.
l
Repair any damage before operating the ARMS.
l
Inspect and perform an operational check on all safeguards and protective devices.
l
In general, repair and/or replacement of damaged or malfunctioning components by Aerotech field service
personnel is not possible. Repair typically requires that the unit be returned to the factory. Please contact
Aerotech Global Technical Support for more information.

4.2. Cleaning and Lubrication

D A N G E R : To minimize the possibility of bodily injury or death, disconnect all electrical
power prior to performing any maintenance or making adjustments to the equipment.
Cleaning
Before using a cleaning solvent on any part of the ARMS, blow away small particles and dust with nitrogen
or, less preferably, clean, dry, compressed air.
Any metal surface on the stage can be cleaned with either acetone or isopropyl alcohol.
W A R N I N G : Make sure that all solvent has completely evaporated before attempting to
move the stage.
Lubrication
There are no elements on ARMS stages that require lubrication.
www.aerotech.com Chapter 4
Maintenance
41