Table of Contents
Advertisement
Section 5
5.1 Programming Overview
Figure 18
9186 Display and Keypad
1.
ESC
Cancels an operation or returns to the next level up.
2.
LEFT ARROW
Validates a selection and passes on to the next step.
3.
RIGHT ARROW
Takes the action as indicated above the key. The action changes depending on the display and menu.
4.
ENTER
Validates the selection indicated above the key. The action changes depending on the display and menu.
Note: If a key is not pressed after
10 minutes, the transmitter returns
to the main display.
Programming the Instrument
On initial startup the instrument will display the Main Screen (see
•
In the Main Screen, use the
Display 2-4 Menus.
•
Display 2 can be programmed to show sample concentration, sample
temperature, and diffusion current.
•
Display 3 shows the status of programmed alarms.
•
Display 4 shows a bar graph of the current analog outputs.
•
In the Main Screen, use the
•
In the Menu screen, use the
selections (programming, calibration, maintenance, and service) and press
to view. Press
ENTER
key to scroll through the menu. See
ARROW
options for each menu selection.
•
Use the
RIGHT ARROW
•
To change a numeric value, select the value with the
the
key to highlight and change the leftmost digit. Press
RIGHT ARROW
to accept the change and move to the next digit to the right.
ENTER
key to view one of the
LEFT ARROW
key to view the Menu screen.
RIGHT ARROW
to navigate through the menu
LEFT ARROW
to go back to the previous screen. Press the
ESC
Table 2
key to scroll through the list of possible values.
Figure
18).
LEFT
for a list of programming
key. Press
LEFT ARROW
23
Advertisement
Table of Contents
