Checking The Ibm Cluster Adapter - IBM 5531 Operator's Manual

Checking the IBM Cluster Adapter
Note: If you do not have an IBM Cluster Adapter, continue with the next section.
The IBM Cluster Adapter is sold with a terminating plug. This procedure requires that you use
that plug.
1.
Disconnect the coaxial cable from the Cluster Adapter's connector.
2. Install the terminating plug (IBM part number 6320352) on the Cluster Adapter's connector
as shown below.
Cluster adapter
connector
Terminating
plug
You have completed connecting the cluster adapter terminating plug. Continue with the next
section.
Chapter 5. Problem Determination Procedures
5-3