Husqvarna PG 400 Petrol Operator's Manual page 10

5. Hold the handlebar to keep the handle stable and lift
the support frame out and up.
6. Select the applicable position for the support frame
and tighten the lock knob. The bottom hole increases
the grinding pressure and the height of the
handlebar. The top hole decreases the grinding
pressure and the height of the handlebar.
7. Put the product in operation position.
Diamond tools
There are many types of diamond tools for the product.
Speak to your approved service center or go to
www.husqvarnacp.com to select correct diamond tool.
10
Installation of the diamond tools
The tool plate uses the RediLock
The installation of the diamond tools on the tool plate
has effect on the performance of the product. The
diamond tool type together with the number of segments
on the diamond tool is important. Always use
symmetrical sets of diamond tools to make sure that the
balance of the grinding head is correct.
Metal bond diamond tools with 1 diamond segment
increases the diamond tool pressure.
For the heaviest removal, we recommend tools that only
have 1 direction of rotation and PCD diamond tool tops.
Note: PCD diamond tools such as the brand Piranha
are made to operate in only 1 direction.
To replace the diamond tools
WARNING: Diamond tools can become very
hot. Use protective gloves.
1. Make sure that the engine is off and that the
operator presence control is not against the
handlebar.
™
Dovetail system.
™
883 - 002 - 10.09.2020