Husqvarna DURATIQ XP6 Operator's Manual page 32

Problem
There are sudden un-
wanted movements
in the product.
Warning and error messages in the
display
The error messages and warnings are shown on the
display on the product. The display shows an error
Symbol Error message
"CONTROL
VOLTAGE LOW"
"HIGH OIL TEM-
PERATURE"
"MOTOR OVER-
LOAD"
"SERVICE"
"WATER LEVEL
LOW"
"EMERGENCY
STOP ACTIVA-
TED"
"GENERIC... ER-
ROR (error
code)"
"HIGH CARBON
MONOXIDE
CONCENTRA-
TIONS"
32
Cause
The grinding discs are worn or damaged.
The diamond tools are incorrectly attached or
attached at different heights on the grinding
discs.
The head locks are loose or missing.
Cause
Low control voltage.
Red symbol, the engine is too hot.
The engine overloads. The display
gauge shows more than 90%.
The engine overloads. The gauge
shows near 100%.
A servicing of the product is necessa-
ry.
The water is low in the water tank.
The emergency stop button is on.
General error converter, left/right
movement engine.
The carbon monoxide values are
higher than permitted levels.
Solution
Examine the grinding discs for damaged
parts and too much movement.
Make sure that all diamond tools are installed
correctly and that all have the same height.
Make sure that all head locks are in position
and tightened.
symbol and a description for the error. If the error
message is yellow, you can continue to operate the
product. If the error message is red, the product stops.
Push "OK" to reset the error. The error is recorded in the
error code record of the product.
Solution
Do a check of the battery voltage.
Stop the engine. Do a check of the oil
cooling fins. If it is necessary, clean
the oil cooling fins.
Decrease the engine load, refer to
the display gauge for engine current.
Let the product become cool.
Speak to your servicing dealer.
Fill water in the water tank. Do a
check of the level sensor.
Reset the emergency stop button.
Go to the support web site.
Make sure that the work area has
good airflow.
1268 - 002 - 25.05.2020