Transportation, Storage And Disposal - Husqvarna DURATIQ XP6 Operator's Manual

Transportation
WARNING: Be careful during transportation.
The product is heavy and can cause injury
or damage if it falls or moves during
transportation.
The wheels let you move the product shorter distances.
For longer distances, lift the product to move it or put the
product on a vehicle.
CAUTION: Do not tow the product behind a
vehicle.
• Be very careful when you move the product
manually or on surfaces with a slope. Small slopes
can result in a fast movement that is not possible to
brake by hand.
• Safety the product during transportation. Make sure
that it cannot move.
• Put some type of protection on the product during
transportation. The protection keeps natural
elements such as rain and snow away from the
product.
• Always use the lifting eye on the product when you
lift the product.
• Do not lift the product by the handlebar, engine,
chassis or other parts.
• Transportation is best done on a pallet.
• Always lift the product with a lift or forklift.
• Do not use a forklift if the product is not put on a
pallet or carriage. This can cause damage to the
grinding discs and other internal components.
• During transportation, the grinding head must be on
the ground. To prevent damage to the lock
mechanism of the tool plates, keep the tool plates
installed.
To set the product in transport position
• Fold down the handle. Refer to
and the handlebar on page 16 .
• Adjust the weights to forward position. Refer to
adjust the weights on page 22 .
1268 - 002 - 25.05.2020

Transportation, storage and disposal

To adjust the handle
To
• Make sure that the grinding head touches the
surface.
• Hang up the grinding head cover. Refer to
up the grinding head cover on page 33 .
To hang up the grinding head cover
WARNING: Be careful when you adjust the
grinding head cover. The moving parts can
cause injury.
The product has 2 rubber straps on each side of the
engine. During transport use the rubber straps to hang
up the grinding head cover to prevent damage to the
surface.
1. Remove the rubber straps from the brackets on the
chassis (A).
A
2. Lift up the grinding head cover.
3. Pull the rubber straps (B).
4. Attach the rubber straps to the brackets on the
chassis (C) to lock the grinding head cover in the
raised position.
To move the product up and down a
ramp
WARNING: Be very careful when you move
the product up and down ramps. The
product is heavy and there is a risk of injury
if the product falls or moves too quickly.
WARNING: For ramps with a steep slope,
always use a winch. Do not walk or stay
below the product. Do not stay in the
To hang
B C
33