Table of Contents
Advertisement
Mounting the cutter
WARNING
Risk of injury!
Make sure that the cutting tool guard (9a) is installed on the cutter (9).
– Loosen the self-locking nut (23) with the circlip
and the washer from the screw (24) with the washer.
– Place the base plate (25) onto the cutter (9).
– Direct the sliding block (26) into the guide (27)
on the cutter (9).
– Align the cutter (9) and the base plate (25) to
one another.
– Direct the screw (24) with the washer from below
through the cutter (9) and the base plate (25).
– Screw the self-locking nut (23) with the circlip
and the washer onto the screw (24) and tighten it.
Using for the first time
Product controls
WARNING
Risk of injury!
Before performing any adjustment work, always switch the product off and remove
the spark plug connector.
Setting the steering height
– Slightly loosen the screws (19) with the circlip
and the washer on both sides of the arm housing
(4).
– Set the desired steering height.
– Tighten the screws (19) with the circlip and
washer again.
Advertisement
Table of Contents
