Table of Contents
Advertisement
Check the safe condition of the product:
– Check whether there is any leakage.
– Check whether there are any visible defects.
– Check whether all parts of the product are firmly attached.
– Check that the safety devices are in faultless condition.
Starting the motor
DANGER
Danger of fire!
Spilled fuel can set the product on fire.
Carefully wipe up any spilled fuel up before starting.
Start the product a minimum of nine metres away from where you filled it.
CAUTION
Product damage!
The motor's durability and operating safety hinges on its run-in time. Always allow
a cold motor to warm up for a few minutes, do not demand full power immediately.
During the first 20 hours of operation (run-in time), do not push the motor to its
performance limit.
– Check motor oil level.
– If the engine is with fuel pump: Set the throttle to position
max. three times. If the engine is with chock: Set the throttle to position
– Slowly pull the pull-starter (13) straight until you feel a resistance.
– Let the pull-starter (13) run in again.
– Keep pulling the pull-starter (13) until the motor starts.
– If the motor does not start, repeat the starting procedure. After starting the motor, set the
required motor speed using the throttle (14).
Note:
Pull the pull-starter max. 50 cm out and let it run back in slowly by hand.
Switching off the motor
WARNING
Risk of injury!
Always switch off the product when not in use for short periods.
– Set the throttle (14) to position
Mowing
WARNING
Risk of injury!
Before beginning work, check the terrain and remove all objects that may be flung
out by the product.
WARNING
Risk of injury!
Never let go of the steering while working.
.
, Press the fuel pump (11)
.
Advertisement
Table of Contents
