Table of Contents
Advertisement
Assembly
Mounting the wheels
WARNING
Risk of injury!
Make sure that the linch pin closes fully.
CAUTION
Product damage!
Pay attention to the running direction of the wheel.
The profile of the wheels must point forward in travel direction.
CAUTION
Product damage!
Always make sure that the tyres have the correct air pressure.
– Push the protectve cap (17) onto the drve
shaft (16).
– Push the wheel (7) with the valve facng
outwards onto the drive shaft (16). If
necessary, first remove the linch pin (18) from
the drive shaft (16).
– Push the linch pin (18) through the hoes in
the rim of the wheel (7) and the drive shaft
(16).
– Close the linch pin (18).
– Repeat the procedure on the other side.
Mounting the arm housing
– Unscrew the screws (19) with the circlip
and the washer on both sides of the product.
– Place the arm housing (4) onto the
product and screw down to the product again
with the screws (19).
Advertisement
Table of Contents
