Master Cut CJF-1001A Operating Instructions Manual page 8

Mounting the steering
CAUTION
Product damage!
Pay attention to the routing of the Bowden cables.
The Bowden cables may neither be routed in too small a radius not may they be
crushed.
– Loosen the self-locking nut (20) with the circlip
and the washer from the round-head screw with
square neck (21).
– Push the steering (3) onto the round-head screw
with square neck (21).
– Screw the self-locking nut (20) with the circlip
and the washer onto the round-head screw with
square neck (21) and tighten it.
Note:
Make sure that the vibration damper (22) between the arm housing (4) and the
steering (3) is installed.
Mounting the Bowden cable guide
CAUTION
Product damage!
Pay attention to the routing of the Bowden cables.
The Bowden cables may neither be routed in too small a radius not may they be
crushed.
– Loosen the self-locking nut (28) with the circlip
and the washer from the screw (29).
– Push the screw (29) with the washer through
the hole in the bracket (30) and the arm housing
(4).
– Screw the self-locking nut (28) with the circlip
and the washer onto the screw (29) and tighten it.