Table of Contents
Advertisement
Installation of drainage hose
■ Instructions for drainage pipe installation.
1. Fix the drainage pipe clip on the right of rear side plate near drainage port with
a screw.
2. Remove the rubber plug at drainage port.
3. Put the drainage pipe into drainage port and screw it up, and then bind it with
pipe hoop.
■ Drainage way as follows.
1. In Cool, Dry or Heat mode operating, the condensation water will be drained to
the chassis.
2. When the chassis is full with water, the buzzer will give out 8 sounds and "H8" is
displayed to remind user to discharge water:
● Move the unit to a suitable place for discharging water;
do not tilt the unit and keep it horizontal during moving;
● Take the drainage pipe from the clip and pull out the
rubber plug on the drainage pipe to discharge water;
● After full water protection is eliminated and the compressor
has been stopped for 3 minutes, the unit will resume operation.
drainage port
drainage pipe
drainage port
drainage pipe clip
screw
pipe hoop
rubber plug
drainage pipe clip
pipe hoop
-27-
Advertisement
Table of Contents
