Husqvarna 555FX Workshop Manual page 56

7
54
Crankshaft and crankcase
Inspecting the
crankshaft
Inspect the large end of the connecting
rod.
Inspect the small end of the connecting
rod.
Check the crank bearing.
Inspect the crankshaft bearing and
sealing rings.
Inspecting the
crankshaft
The crankshaft cannot be reconditioned
but must be replaced if it is worn or
damaged.
Inspect the large end of the connecting
rod. If seizure marks, discolouration on
the sides or damaged needle holders
are found the crankshaft must be
replaced.
Inspect the small end of the connecting
rod.
If seizure marks or discolouration are
found in the bearing track the crankshaft
must be replaced.
Check the crank bearing. The
connecting rod shall not have any radial
play (up and down).
It should, however, have axial play, in
order to ensure good lubrication of the
crank bearing among other things.
Check for wear in the crankshaft bearing
and sealing rings.
Clean the bearings and rotate the outer
ring. If movement is "jerky" the bea-
ring track is probably damaged. If so,
replace the bearing.
Also check that the gap is not too great.
Inspect the sealing rings. The seal edge
shall be sharp or slightly ground.