Assembly; Dismantling The Clutch Drum - Husqvarna 555FX Workshop Manual

4
34
Centrifugal clutch

Assembly

Temporarily place the clutch shoes on
the clutch hub and loosely tighten the
screws.
Pry out the shoes and hook one spring
to each shoe from underneath.
Dismantling the clutch
drum
Dismantle the clutch cover with clutch
drum from the shaft.
502 50 18-02
Pull out the sealing sleeve and
dismantle the circlip.
Assembly
Temporarily place the clutch shoes on
the clutch hub and loosely tighten the
screws.
Pry out the shoes and hook one spring
into the cut-out in each shoe from
underneath.
Insert the clutch shoes as far as
possible and hook the springs to the
adjacent clutch shoe from above as
shown in the detailed fi gure.
Use a small screwdriver or fl at-nosed
pliers.
NOTE!
Make sure that the spring eye is
pressed into the correct position.
Remove the screws and put the cover
plates in position.
Tighten the bolts, fi t the clutch to the
crankshaft and the remaining parts
in the reverse order as set out for
dismantling.
Dismantling the clutch
drum
Separate the engine body and shaft as
described previously.
1. Remove the screws (A) holding the
clutch cover against the shaft.
2. Lift off the plate with locking pin (B).
3. Pull the clutch cover with the clutch
drum away from the shaft.
Pull out the sealing sleeve (C) from the
clutch. (Sometimes this can remain in
the shaft.)
Dismantle the circlip (D) from the stub
axle with the help of circlip pliers.