Replacing The Spark Plug Cover - Husqvarna 555FX Workshop Manual

2
10
Electrical system
Still no spark?
Check the air gap.
502 51 34-02
Adjust the air gap.
Replacing the spark
plug cover
1. Insert the ignition cable through the
spark plug cover.
2. Make a hole in the ignition cable for
the ignition coil.
502 50 06-01
3. Attach the ignition coil to the ignition
cable.
NOTE!
It is important that the tip of the ignition coil hits the centre of the ignition
cable to prevent sparking.
Still no spark?
Dismantle the starter, air guide plate
and the guard over the muffl er.
Check the air gap between the fl ywheel
magnet and the ignition module. The
gap should be 0.3 mm.
Use a 502 51 34-02 feeler gauge.
Adjust the air gap as needed to the
correct value.
• Loosen the bolts.
• Position the feeler gauge and press
the ignition module against the
fl ywheel.
• Tighten the bolts and check the air
gap again.
If the spark plug still does not fi re, the
ignition system should be replaced.
Replacing the spark
plug cover
1. Lubricate the ignition cable with a
little grease and thread it through the
spark plug cover.
2. Cut off a bit of the ignition cable
(approx. 5 mm) and make a hole in
the cable for the ignition coil with
the aid of a pair of no. 502 50 06-01
pliers.
3. Attach the ignition coil to the ignition
cable and ensure that the wire is
folded along the cable.
4. Pull the ignition coil into the spark
plug cover.