Assembling.the.keypad - Husqvarna LiHD50 Workshop Manual

Repair instructions LiHD60X / LiHD70X
10.11 Assembling the keypad
Steps 1-3 should only be carried out when
replacing the keypad with a new one.
1
Clean/degrease the surface where the keypad is
mounted.
See figure 31.
2
Make sure the temperature is at least 15°C and the
surface where the keypad is mounted differs no
more than ± 3°C from the ambient temperature.
See figure 32.
3
Remove the protective tape from the new keypad
and press it onto the holder. Press on the keypad
with 10 N/cm² for at least 10 seconds.
NOTE!
Do not bend the keypad when assembling.
See figure 33.
4
Snap on the keypad with holder in the bracket (D)
and place the flat cable into the grooves in the
bracket.
NOTE!
The flat cable to the keypad is very fragile.
See figure 34.
5
Plug in connector (A).
See figure 35.
50 – English
Fig.31
>15°C
Fig.32
10 N/cm 2
Fig.33
Fig.34
Fig.35
>10 sec
C
D
A