4
Thread the cable through the O-ring and the fast-
ener. Lubricate the O-ring sparingly with grease to
facilitate assembly.
See figure 43.
NOTE!
The fastener can only be pressed onto the
handle when the groove in the fastener and
the heel on the handle engage. Also check
that the O-ring is positioned correctly in the
fastener.
5
Press the fastener onto the handle.
See figure 44.
6
Pull out the handle stop and turn one half revolu-
tion clockwise until the handle stop comes into
place.
See figure 45.
7
Place the handle in the chassis and fasten with
screws (4x).
Tightening torque 3 ~ 4 Nm.
See figure 46.
8
Connect contact (A) and place the cables with clips
(B) in the chassis
See figure 47.
Repair instructions LiHD60X / LiHD70X
Fig.43
Fig.44
C
/
1
2
Fig.45
Fig.46
B
Fig.47
D
A
English
53
–