Husqvarna K 750 Workshop Manual page 31

12
502 50 70-01
30
CYLINDER/PISTON
Remove the cylinder base gasket.
Tool kit 502 50 70-01
The tool kit contains piston
ring compressors, a piston stop,
and a support plate for the
piston.
The piston stop must not be
used on K750.
Piston
Dismantling
Place the support plate under
the piston.
Seal with a cloth or paper so
as not to risk anything falling
down into the crankcase.
Dismantle the circlips on both
sides of the gudgeon pin.
Remove the cylinder base gasket.
Tool kit 502 50 70-01
The tool kit contains, to the left, piston
ring compressors to press together the
piston rings when assembling.
The middle tool is a piston rod which
must not be used on K750.
The support plate to the right is placed
between the piston and the crankcase to
facilitate the work.
Piston
Dismantling
Place the support plate under the piston.
Seal with a cloth or paper so as not to
risk anything falling down into the
crankcase.
Dismantle the circlips on both sides of
the gudgeon pin using a pair of pliers.
Turn and press together the circlip at the
same time as it is pulled outwards.