Dismantling Into Basic Modules - Husqvarna K 750 Workshop Manual

DISMANTLING INTO BASIC MODULES

1
1
3
5
2
2
4
6
Basic modules
This chapter shows how the machine is
built up of basic modules, for example,
the starter, carburettor, air filter system,
etc.
The purpose is to illustrate how you
can easily and effectively dismantle and
assemble the machine in its basic modules.
Service work on a component level, for
example, replacing the starter cord, is
described in detail in respective chapters.
Starter
1. Loosen the 4 screws on the guard.
2. Dismantle the starter.
Cutting arm
1. Loosen the screws on the cutting head.
2. Slacken off the belt tension using the
adjuster screw. Dismantle the screws on
the cutting head.
3. Dismantle the front belt cover by
sliding it forwards.
4. Loosen the hoses by the water valve.
Lift off the belt from the pul ley and
remove the cutting head.
5. Loosen the two screws on the rear belt
guard.
(Tightening torque when assembling
6.6–8.1 lbf·ft/9–11 Nm.)
6. Remove the guard.
4
5