Husqvarna K 750 Workshop Manual page 8

DISMANTLING INTO BASIC MODULES
5
!
7
1
3
1
6
2
2
3
Assembly
5. Hook the throttle rod into the valve
arm as illustrated. Lift the carburettor
unit into position and fit the fuel hose.
Press down the throttle rod into throttle
control with the help of a pair of pliers.
6. Align the carburettor's choke arm in
the blue choke control.
7. Fit the carburettor unit. Align the lug
on the flange with the cut-out on the
cylinder. Tighten the screw at the top.
Carburettor compartment
1. Tank venting
This is dismantled by angling the unit
backwards and then pulling it out the
tank.
2. Stop switch
This is secured by a screw in the carburet-
tor compartment.
3. Controls
The controls in the rear handle be come
accessible for service once the carburettor
unit has been dismantled.
Air duct
First dismantle the starter.
1. Lower air duct
Note, to facilitate reassembly, how the
cable to the stop switch is fitted in the
air duct. Lift the cable out of its
mounting.
2. Upper air duct
Loosen the ignition lead by the spark
plug and lift the cable out of its
mounting in the cover.
3. The engine's earth point
The engine's earth point to the stop
button is located here
4
7