Handling Unit After Removal From Skid; Figure 2A Unit On Lift; Figure 2B Unit Side - Bard I-TEC Series Installation Instructions Manual

HANDLING UNIT AFTER REMOVAL FROM
SKID
If a wide and tall opening exists, the I-TEC can be
moved as a complete assembled unit. If not, use the
following directions for dis-assembly to allow it to pass
through a 36" wide door.
1. Depress and release both top and bottom door
latches and open doors.
2. Remove doors by lifting straight up and off from
the hinge pins.
3. Remove cabinet sides by first removing the four
(4) sheet metal screws from the front (leading
edge) of the side panel. The panel will not fall
off. Swing the panel away from the chassis
20-30˚ and then pull forward from the two tabs
supporting the rear edge. At this point, the unit
can be tipped on its left side enough to get dolly
carts under it. Use dolly carts to move unit into
installation area. Use care not to damage vent
wire harness. This method is not suggested
due to unit weight and if a forklift or unit lift is
available, continue with the following steps for
separation of top section and bottom base.
FIGURE 2A
Unit on Lift
LEFT
SIDE
of
UNIT
4. On each side of the unit is a tie plate that secures
the top and bottom sections with four (4) cap
bolts. Using a ½" wrench or socket, remove these
screws from both plates and set aside.
5. If the unit is equipped with a CRV, unplug the
wire harness on the left-hand side of the control
box.
6. A forklift or a lift rated for the load is required to
lift the top section off from the bottom base. Do
not attempt to do this manually! Failure to do so
could result in the unit tipping over and causing
bodily injury and/or damage to the unit.
7. The top section can be forked from either the
right-hand or left-hand side. See Figure 1 for fork
openings.
8. Carefully lift the top section straight up avoiding
tipping.
9. Move the top section through the doorway and
place on flat surface free of debris.
10. The bottom base can now be moved through the
doorway the same way.
11. Reassemble the unit by reversing this procedure.
FIGURE 2B
Unit Side
CRV
HARNESS CONNECTION
(4) CAP BOLTS
FORK OPENING
(Visible after
removing tie plate)
TIE PLATE
(Covers entire width; shortened for illustration
purposes to show Fork Openings)
Manual 2100-578L
Page 9 of 42