Shipping Damage; Unit Removal From Skid; Center Of Gravity; Center Of Gravity Table - Bard I-TEC Series Installation Instructions Manual

CENTER OF GRAVITY

"X"
"Y"
Unit Tested
I36Z1-A, B
I36Z1-C
I48Z1-A, B
I48Z1-C
I60Z1-A, B
I60Z1-C

SHIPPING DAMAGE

Upon receipt of equipment, the unit should be checked
for external signs of shipping damage. The skid must
remain attached until the unit is ready for installation.
If damage is found, the receiving party must contact
the last carrier immediately, preferably in writing,
requesting inspection by the carrier's agent.

UNIT REMOVAL FROM SKID

WARNING
This unit is heavy and requires more than one person
to handle during installation and removal from the
skid. Extreme caution must be taken to prevent injury
to personnel and damage to the unit. Use appropriate
safety equipment, including gloves when handling.
Failure to do so may result in serious injury.
Manual 2100-578L
Page 8 of 42
Center of Gravity
FRONT OF UNIT
DOOR TO CENTER
"X" Dimension "Y" Dimension
13½"
13½"
13½"
13½"
13½"
13½"
LEFT SIDE FLOOR TO CENTER
TO CENTER CRV & ERV
"Z" Dimension
31"
31½"
31"
31½"
31"
31½"
A forklift or a lift rated for the load (Figure 2A) is
required to lift the unit off from the skid. This unit is
top heavy and should never be tipped while moving it.
The I-TEC is designed to be lifted off the skid from the
front or rear of the unit without having to remove any
doors or side panels. See Figure 1 for fork openings.
The shipping brackets on front and rear of the unit must
be removed and discarded. The unit can now be lifted
straight up and the skid can be slid out from underneath.
Tip unit from left side only.
Failure to do so may result in injury due to unit
top-heaviness or compressor damage!
MIS-3268
FLOOR TO CENTER
NO VENT
MIS-3268
"Z" Dimension
43½" 47"
43½" 47"
43½" 47"
43½" 47"
43½" 47"
43½" 47"
"Z"