Troubleshooting; Faults; No Good Pid Regeneration; Resetting The Pidbox Light - ILUMEN PIDBOX LIGHT Installation Manual

Ilumen
10 T
ROUBLESHOOTING
10.1 F
AULTS
LED readout
No leds visible
No leds visible
Led gives other color
than BLUE, GREEN,
WHITE, CYAN,
PURPLE or RED
No RED or PURPLE
led during nighttime
while during the day
blue led is burning
Red led blinking
during the night
10.2 N PID
O GOOD
If the modules are not regenerating or not regenerating fast enough you should check following
things:
✓ Check the grounding of the system. If necessary you should place additional
interconnections between the frames of the modules.
✓ Is the Ilumen PIDbox Light properly connected to the grid?
✓ Is the DC power supply properly connected (is its indication light burning)?
✓ Let an expert check if the problem you're having with the yield is caused by PID
10.3 R
ESETTING THE
The PIDbox Light can simply be reset by unplugging the DC-power cable. Wait 10 seconds and
connect the DC-power cable back to the PIDbox Light.
If resetting does not help fixing your problem, please consult chapter 10.1 of this manual.
10.4 R
EPAIRING THE
Do not try to open up the PIDbox Light by yourself. This will void the warranty
Installation Manual Ilumen PIDbox Light v1.2
Fault
Product does not work
Product does work and
makes some clicking
noises
Product does not work
Curing of the panels is not
working
Product does not work
REGENERATION
PID L
BOX IGHT
PID L
BOX IGHT
Corrective action
Make sure the DC-power supply is
plugged into a AC-outlet. Also make
sure the outlet is under tension.
This can happen at dusk and dawn. LED
should light up after a while. If not
please contact iLumen technical
service.
Please contact iLumen technical
service.
This can have 2 reasons:
•
PID is not present on PV-
modules (however the first
night of regeneration the led
must be on).
•
Earth connection between
PIDbox Light and the frame of
the modules is interrupted
If you connected the PIDbox when it
was already dark outside, the PIDbox
will not become active during that 1
night. Normally the PIDbox Light
should work the nights after that when
the solar plant has been active during
the day.
st
18