Installation Summary - ILUMEN PIDBOX LIGHT Installation Manual

Ilumen
RED FAST BLINKING: power supply connected but no active solar system
✓
detected
BLUE BLINKING: active solar system detected and waiting for activation (30
✓
minutes waiting period.) This is normal startup behavior.
BLUE CONTINIOUS:
✓
at night
GREEN BLINKING: all startup conditions are met and PIDbox Light will start in
✓
less than 30 minutes
RED: PIDbox Light active at night time
✓
PURPLE: (OUTDOOR only) purple led can burn at night time. May switch to
✓
It is normal for the LED to be out at the beginning and at the end of the night
After start-up you may turn the DC switch of the inverter back on, followed by the AC side of the
PV plant.
8 I
NSTALLATION SUMMARY
1) Take the necessary safety precautions (AC side of the PV plant off and DC switch of the
inverter off).
2) Mount the Ilumen PIDbox Light on a flat surface or if not available mount it correctly to a
wall using the wall bracket.
3) Connect the Ilumen PIDbox Light earth pin to the frames of the PV modules and check
the interconnections between the PV casings.
4) Disconnect the PV array cables from the inverter.
5) Connect the PV array cables to the Ilumen PIDbox Light inputs (see
6) Connect the DC power supply to the Ilumen PIDbox Light.
7) Plug the DC power supply into an outlet (LED of the Ilumen PIDbox Light lights up if the
PVs are producing electricity)
Installation Manual Ilumen PIDbox Light v1.2
active solar system detected and activated, ready for curing
RED
6.2 for details).
16