Connecting The Solar Modules; Using Splitter Cables - ILUMEN PIDBOX LIGHT Installation Manual

Ilumen
6.3 C
ONNECTING THE SOLAR MODULES
The maximum amount of PV-power that can be attached to 1 PIDbox Light is 100kWp. This is
the total of panels attached to input A and B. Make sure this is not exceeded to insure a good
result.
You can apply 2 ways of attaching solar modules to the PIDbox Light. One is with splitter cables
and the other is with using free inputs on your inverter. We will explain both ways in the
sections below.
6.3.1 U
SING SPLITTER CABLES
With the use of a splitter (1 to 2) you can simply hook up your PIDbox Light. Simply detach a
string from the 1 MPPT. Insert the splitter (the end with 1 connector) into the input from the 1
st
MPPT of the inverter. Use the connectors on the other side of the splitter cable to connect the
solar array and the PIDbox Light A side. Make sure you connect the positive pole to the
"PV in A +" side of the PIDbox Light. Do the same for the negative side of the 1
you use the opposite splitter.
The 2 MPPT is connected the same way as the 1
nd
the PIDbox Light.
Installation Manual Ilumen PIDbox Light v1.2
MPPT. Connect these 2 cables to the B-side of
st
st
MPPT. Make sure
st
10