Decommissioning The Ilumen Pid Solution; Disassembling The Pidbox Light; Packing The Pidbox Light; Disposing Of The Pidbox Light - ILUMEN PIDBOX LIGHT Installation Manual

Ilumen
8) Turn the DC switch from the inverter back on followed by the AC side of the PV plant
9 D
ECOMMISSIONING THE
9.1 D
ISASSEMBLING THE
Switch off the Ilumen PIDbox Light. Disconnect the Ilumen PIDbox Light from the AC grid. Wait
for minimum 20 minutes. Make sure the AC cannot be plugged in again. Disconnect the DC
switch from the inverter and wait until it is discharged. Disconnect all DC connectors going to
the PV arrays and then disconnect the lines going to the inverter. When all electrical connections
are disconnected you can dismount the Ilumen PIDbox Light.
When doing any kind of work on the PIDbox Light, always disconnect the
DC power plug from the device before unplugging any PV-cables.
9.2 P PID
ACKING THE
To pack the PIDbox Light use the original packaging or packaging suitable for the weight and
dimensions of the PIDbox Light (see Section 12 "Technical Data").
9.3 D
ISPOSING OF THE
Dispose of the PIDbox Light at the end of its service life in accordance with the disposal
regulations for electronic waste currently applicable at the installation site.
Installation Manual Ilumen PIDbox Light v1.2
3
7
I
LUMEN
PID L
BOX IGHT
L
BOX IGHT
PID L
BOX IGHT
8
PID S
OLUTION
17