Protection Fuses - ILUMEN PIDBOX LIGHT Installation Manual

Ilumen
6.4 P
ROTECTION FUSES
It is obliged to place protection fuses in front of the PIDbox Light. There are 2 ways of doing this.
The first is placing an electrical cabinet with din-rail fuse holders in it. The fuses must be rated
1000V DC and have a breaking current of 2Amps. The fuseholder also has to be rated 1000VDC.
Each input of the PIDbox Light must be protected by a fuse of 2Amps.
The second way is to place a cable/connector with fuses inside them like the picture below.
Again the fuse will need to have a 1000VDC rating and must break at 2 Amps.
It is obliged to place protection fuses in front of the PIDbox Light. The fuses must
be rated 1000V DC and have a breaking current of 2Amps. Each input must be
protected
Installation Manual Ilumen PIDbox Light v1.2
or
13