Commissioning; Check; Starting Up The Ilumen Pid Utility - ILUMEN PIDBOX Installation Manual

Ilumen
7 C
OMMISSIONING
7.1 C
HECK
Do a final check whether everything is properly mounted and connected (see chapter 5 and 6 for
details):
 The PV frames are all connected to the same earth as the earth pin of the Ilumen PIDbox
utility
 The PV and inverter DC cables are correctly connected
 The AC connection is made properly
If all these points are installed correctly you can start up the Ilumen PIDbox utility.
7.2 S
TARTING UP THE
The Ilumen PIDbox utility can only work in an automatic mode. To start up the Ilumen PIDbox
utility, switch on the AC circuit breaker. Next see if the light on the Ilumen PIDbox utility starts
burning. After checking the system it will be switched on automatically.
When the Ilumen PIDbox utility is hooked up correctly to the inverter you will see the following
status light readouts.
White: device is switched on

RED: DC circuit breakers are off. This light should burn during the night (starting from

22.30h)
GREEN:. DC circuit breakers are on. This light should burn during the day (starting

from 04.30h)
BLUE: PID controller is switched on and cures the PV system. It takes a minute or so

that the blue light will come on after the red light starts to light up.
So there are 2 scenarios:

Daytime: white light and green light on

Nighttime: white light, red light and blue light on
Installation Manual Ilumen PIDbox Utility v1.0
I PID
LUMEN UTILITY
11