Finishing The Fireplace; Servicing; Repair Parts; Parts List - Temco PRESTIGE Series Installation Instructions Manual

There are a wide variety of finishing materials available for
your fireplace from formal wall treatments with marble and
mantels to rustic wood paneling, stone or brick.
IT IS IMPORTANT THAT THE BLACK FACE OF THE
FIREPLACE NOT BE COVERED WITH ANY TYPE OF
COMBUSTIBLE MATERIAL.
Noncombustible facing materials such as marble, brick or
ceramic tile may overlap the black face of the fireplace up to
the opening on either side of the fireplace. Seal all joints
between the black fireplace face and the wall covering with
a heat-res istant material such as rock wool insulation or
mortar. Be sure to use high temperature adhesive or
mortar when anchoring brick, stone or tile to the face of the
fireplace. Check to see whether man-made brick and stone
are made of noncombustible materials before using them
on the face of the fireplace.
contain combustible materials. Combustible wall coverings
Repair and replacement work should only be done by a
qualified service person.
A parts list follows. Always include correct name, part
number and model number of the appliance when ordering
service parts.
If you desire to communicate with the factory, write to
Customer Service at:
FIREPLACE PARTS
Firescreen rod
Screw for firescreen rod
Firescreen w/rings
Screen Retainer
Left Brick Panel
Right Brick Panel
Back Brick Panel
FINISHING YOUR FIREPLACE
Some of these products

SERVICING

REPAIR PARTS

PARTS LIST

39" models
Part #
76397
68188
72301
62222
77529
77528
77530
such as paneling or wallboard may not overlap the black
face of the fireplace. The space between the wall covering
and the fireplace should be sealed with a heat-resistant
material such as rock wool insulation or mortar. If covering
the dace with a noncombustible, use the flush panel kit. Do
not place facing material directly over the louvered
openings.
NOTE: An "L" shaped steel lintel must be installed across
the top of the firebox opening where facing materials such
as brick or stone are used on the face of the firebox. It acts
as a support/firestop. It should be attached to the face of
the fireplace with screws and sealed to the fireplace with a
heat-resistant sealer.
WARNING: THESE VENT FREE FIREPLACES ARE
NOT TO BE USED WITH GLASS DOORS.
Always shut off the gas supply and make sure the
appliance is cool before beginning any service operation.
Always check for gas leaks after servicing.
TEMCO FIREPLACE PRODUCTS, Inc.
P. O. Box 1349 Manchester, TN 37349
TEMCO FIREPLACE PRODUCTS, Inc.
P.O. Box 1148 Perris, CA 92572
45" models
Qty. Part #
2 76397
2 68188
2 72301
4 62222
1 76285
1 76276
1 76292
6
or
Qty.
2
2
2
4
1
1
1