Table of Contents
Advertisement
6.2 JMicron
RAID Configurations
®
The JMicron
Serial ATA controller allows you to configure RAID 0, RAID
®
1 and JBOD sets on the external Serial ATA hard disk drives.
6.2-1 Before creating a RAID set
Prepare the following items:
1.
Two SATA HDDs, preferably with the same model and capacity.
2.
A write-enabled floppy disk
3.
Microsoft
Windows
®
®
4.
Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1.
Install the external Serial ATA hard disk drives (HDDs) on your
system.
2.
Set the SATA2 Controller item in the BIOS to .RAID Mode..
See section " Onboard Device " for details.
6-6
OS installation disk (Windows 2000/XP)
Phoenix-AwardBIOS CMOS Setup Utility
Onboard Device
SATA Mode
[IDE]
USB Controller
[Enabled]
USB 2.0 Controller
[Enabled]
USB Keyboard Support
[Enabled]
USB Mouse Support
[Enabled]
Onboard 1394 Device
[Enabled]
RTL CLAN Device
[Enabled]
Onboard LAN Boot ROM
[Disabled]
Intel GLAN Device
[Enabled]
Azalia Codec
[Enabled
SATA2 Controller
[RAID Mode]
: Move
Enter: Select
+/-/PU/PD:Value
F5:Previous Values
F6:Performance Defaults
3.
Enter the JMB363 RAID BIOS utility to set up your RAID con-
figuration.
4.
Create a JMB363 RAID driver disk for Windows
See section "Creating a RAID driver disk" for details.
5.
Install the JMB363 driver after the Windows
stalled.
Item Help
Menu Level
F10:Save ESC:Exit
F1: General Help
F7:Optimized Defaults
®
OS installation.
®
OS had been in-
Advertisement
Table of Contents
