Water Hardness; Autodos (Automatic Dispensing) - Miele G 7960 Operating Instructions Manual

Water hardness

Your dishwasher is fitted with a water
softener.
- You should programme the dish-
washer to the correct water hardness
for your area.
- Your local water authority will be able
to advise you of the water hardness
level in your area.
- Where the water hardness fluctuates
e.g. between 1.8 and 2.7 mmol/l (10–
15 °dH - German scale) always pro-
gramme the dishwasher to the higher
value (2.7 mmol/l or 15 °dH in this ex-
ample).
If the water hardness in your area is
available in a unit other than °dH, you
can convert the values as follows:
1 °dH = 0.18 mmol/l = 1.78 °fH
Setting the water hardness level
 Select the water hardness level in
your area and confirm using OK.
AutoDos (automatic dispens-
ing)
If you later wish to change the fill level
or dispensing amount of the PowerDisk,
you can adjust the pre-set values ac-
cording to the information on the pack-
aging.
These settings are important in order for
the
PowerDisk almost empty
be displayed correctly. These settings
have no influence on the amount of de-
tergent dispensed in each wash pro-
gramme.
Setting PowerDisk fill level
The PowerDisks currently available con-
tain 400 g of detergent.
 Select the
PowerDisk fill level
tion and confirm with OK.
 Enter the PowerDisk fill quantity and
confirm with OK.
Setting Dosage amount
The PowerDisks currently available dis-
pense approximately 7 g of detergent
per rotation.
 Select the
Dosage amount
tion and confirm with OK.
 Select the dispensing quantity of the
PowerDisk and confirm with OK.
Settings
message to
menu op-
menu op-
37