Miele G 7960 Operating Instructions Manual page 121

A stopcock with a ¾" threaded union is
required for the connection. If a stop-
cock is not available, a qualified
plumber should connect the dishwasher
to the domestic water supply.
A non-return valve is not required. The
appliance meets the requirements of
the applicable DIN standards.
The water-connection pressure needs
to be between 50 and 1,000 kPa. If the
water-connection pressure is too high,
a pressure reducing valve must be fit-
ted.

Risk of damage from leaking wa-
ter.
The connection point is subject to
mains water pressure. Water leaking
from it can cause damage.
You should therefore open the stop-
cock slowly and check for leaks.
Correct the position of the washer
and screw thread if appropriate.

Risk of damage due to excessive
pressure.
A brief increase in the water pressure
can damage components of the
dishwasher.
This dishwasher must only be oper-
ated when it is connected to a fully
vented plumbing system.

Risk of electric shock from mains
voltage.
There are electrical components in
the water inlet hose.
The inlet hose must not be shortened
or damaged in any way (see illustra-
tion).
Installation
121