Refilling The Salt - Miele G 7960 Operating Instructions Manual

Before using for the first time

Refilling the salt

 When 
Add salt and run the
"QuickPowerWash" programme with the
"Express" option without a load
in the display, wait until the end of the
programme and then refill the salt
reservoir.
 Confirm with OK.
The salt refill indicator will go out.

Risk of corrosion due to saline
solution.
Saline solution that runs out can
cause corrosion in the wash cabinet
and to the load items.
Each time you remove the salt reser-
voir cap, you must run the
 65 °C QuickPowerWash pro-
gramme with the  Express pro-
gramme option selected without any
load items in the dishwasher. This
will dissolve and remove any traces
of salt from the wash cabinet.
32
After the salt reservoir has been filled,
the salt refill indicator may still appear in
the display if the salt concentration has
not yet reached the correct level. In this
appears
case, confirm the message again with
OK.
The salt refill indicator will be switched
off if you have programmed the dish-
washer for a water hardness below
0.9 mmol/l (5 °dH – German scale).