Download Print this page

Adjusting The Refrigerator Shelves; Removing The Crisper, Trivet And Crisper Cover; Changing The Light Bulb; Ice Cube Trays - Whirlpool ETl8SC Use And Care Manual

No-frost refrigerator- freezer
Hide thumbs


Table of Contents
Adjusting the refrigerator
1 First, remove food from shelf
2. Slide shelf straight out to stop
3 Lift front
Slrde the rest of the way out
1 Frt back of shelf on top of guides with wire stops
on the bottom
of guides
2 Lift front, slide shelf in untrl it clears guide stops
Removing the crisper, trivet and
crisper cover...
Removing crisper:
I. Slide crisper straight out to stop
2 Loft the front.
3 Slrde the rest of the way out.
4 Replace
in reverse order
Removing trivet:
I, Lift the trivet from the support brackets on the back
2 Replace
in reverse order
Removing cover:
1. Lift front, then lift back.
2. Pull up and out.
1 Fit notches on back of cover into supports on back
wall of refrigerator.
2. Lower front into place
Changing the light bulb.. .
WARNING: Before removing the light bulb, either
unplug the refrigerator
or disconnect
the electricity
to the re-
at the main power supply.
Shock and injury can occur if elec-
tricity remains connected.
1 Reach behind control console to find bulb
2 Remove bulb
3. Replace
with a 40-watt appliance
Ice cube trays...
, ,
1, \
To remove ice:
1. Hold tray at both ends.
2. Slrghtly twist.
Shelf Guide
I 'I
Lift the Front, Then the Back.
Pull out to stop.
Lift the Front and Pull Again.
If cubes are not used, they may shrink. The moving
cold oir starts a slow evaporation.
The longer cubes
are stored, the smaller they get.


Table of Contents

  Related Manuals for Whirlpool ETl8SC

This manual is also suitable for: