Install Properly; Level Refrigerator-Freezer; Remove Soles Labels; Clean It - Whirlpool ETl8SC Use And Care Manual

No-frost refrigerator- freezer
Table of Contents

Advertisement

I
1 I'
Install properly.. .
111;)i
0
1
I
1. Allow 3 inches (7.5 cm) between
overhead
cab-
Inets and the refrigerator
top
2. Allow at least an Inch (2.5cm) between
the refrlg-
erator condenser
and the wall
3. Allow % inch (1.25 cm] on each side of the rem
frigerator
for ease of lnstallatlon
4 If the refrigerator
IS to be agolnst a wall, you might
want to leave enough space so the door can be
opened
wider
Level refrigerator-freezer...
Levelli
This refrigerator
has 2 threaded
levelling
legs that
are shipped
in a separate
package.
1. Screw these legs all the way into bolt holes in the
bottom
front corners of the refrigerator.
2. Slide the refrigerator
into place.
3. Adjust front legs to level the refrigerator.
-To raise corners, turn legs in direction
shown.
- To lower corners, turn legs in direction
shown.
4. Check
with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
inslde
labels before using the refrigerator.
To remove any remaining
glue:
1 Rub briskly with thumb to make a ball then remove
OR
2 Soak area with dishwashing
detergent
solution (1
teaspoon
detergent
in 1 quart warm water) before
removing
glue as described
in step 1.
DO NOT USE rubbing alcohol
or flammable
or
toxic solvents, such as acetone,
gasoline,
car-
bon tetmchloride,
etc. These can damage
the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened
under
the refrlgemtor
at the front.
Clean it...
Clean your refrigerator
before using It See clean-
Ing instructions on page
7
Plug it in...
3-prong
grounding
plug
t
Refrigerator
Power Cord
RECOMMENDED
GROUNDING
METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere
fused
and
properly
grounded
electrical
supply
is re-
quired.
It is recommended
that a separate
circuit
serving only this appliance
be provided.
Do not use an extension
cord. Use a recep-
tacle which cannot
be turned off with a switch
or pull chain.
See individual
electrical
require-
ments and grounding
instruction
sheet in your liter-
ature package.
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Et18sc

Table of Contents