Table of Contents
Advertisement
IIVTE0
Video Terminal
WBPEEUI220760A0
the number by one; the button below the window increases the
number by one. Set the address to 1.
NOTE: If the SCSI ID is changed, it will be necessary to power cycle
the optical disk drive so that the drive recognizes the new ID. It may
also be necessary to reboot the host system.
To set the operation mode, use the following procedure.
1. Locate the operation mode switch on the rear panel of the
disk drive.
2. To set the operation mode, push in on the button directly
above or below the operation mode window with a small screw-
driver or the point of a pen. A small screwdriver is shipped with
the unit.
3. The button above the window decreases the number by
one; the button below the window increases the number by
one. Set the operation mode to 0.
NOTE: If the operation mode is changed, it will be necessary to
power cycle the optical disk drive so that the drive recognizes the
new mode. It may also be necessary to reboot the host system.
Read the instruction manual shipped with the unit. It contains
important installation, connection and troubleshooting infor-
mation.
When using a driver cabinet, a VT100 compatible dumb termi-
nal, personal computer, etc. is required as an alternate console
capability to perform configuration requirements and mainte-
nance. The IIVTE0 video terminal provides this alternate con-
sole capability. The IIVTE01 is 120 VAC, the IIVTE02 is 220/
240 VAC.
Refer to Figure
3-22
for IIVTE0
connections. Refer to
ETHERNET CONFIGURATIONS
tional information. Complete the proper connections. Refer to
the File Utilities and Configuration instruction manuals
(Table 1-3) for configuration information.
INSTALLATION
video terminal location and
for addi-
PERIPHERALS
3 - 37
Advertisement
Table of Contents
