Table of Contents
Advertisement
INSTALLATION
IIVTE0_ Video Terminal
PERIPHERALS
3 - 36
There are two hardware settings that must be made to the opti-
cal disk drive; the SCSI address setting and operation mode
setting. Set the SCSI address using the following steps.
1. Make sure the power to the optical disk drive is off.
2. Locate the SCSI ID switch on the rear panel of the disk
drive.
3. Set the SCSI ID by pushing in on the button on the rear
panel that is directly above or below the address window with a
small screwdriver or the point of a pen. A small screwdriver is
shipped with the unit. The button above the window decreases
the number by one; the button below the window increases the
number by one. Set the address to 1.
NOTE: If the SCSI ID is changed, it will be necessary to power cycle
the optical disk drive so that the drive recognizes the new ID. It may
also be necessary to reboot the host system.
To set the operation mode, use the following procedure.
1. Locate the operation mode switch on the rear panel of the
disk drive.
2. To set the operation mode, push in on the button directly
above or below the operation mode window with a small screw-
driver or the point of a pen. A small screwdriver is shipped with
the unit.
3. The button above the window decreases the number by
one; the button below the window increases the number by
one. Set the operation mode to 0.
NOTE: If the operation mode is changed, it will be necessary to
power cycle the optical disk drive so that the drive recognizes the
new mode. It may also be necessary to reboot the host system.
Read the instruction manual shipped with the unit. It contains
important installation, connection and troubleshooting infor-
mation.
When using a driver cabinet, a VT100 compatible dumb termi-
nal, personal computer, etc. is required as an alternate console
capability to perform configuration requirements and mainte-
nance. The IIVTE0
video terminal provides this alternate con-
_
sole capability. The IIVTE01 is 120 VAC, the IIVTE02 is 220/
240 VAC.
Refer to Figure
3-21
for IIVTE0
connections.
video terminal location and
_
WBPEEUI220754A0
®
Advertisement
Table of Contents
