Changing The Light Bulbs; Removing The Base Grille - Whirlpool B2lDK Use And Care Manual

Changing the light bulbs
Electrical Shock Hazard
Before removing a light bulb, either
unplug the refrigerator or disconnect the
electricity leading to the refrigerator at
the main power supply.
Failure to do so could result in electrical
shock or personal injury.
To change the refrigerator light:
1.
Disconnect refrigerator from power supply.
2. Push lightty on top center of light shield until the
notched tabs unhook from the Control Panel.
3. Pull light shield down until the tabs clear the
Control Panel.
4. Lii back hooks of light shield out of their slots.
5. Replace with a 40-watt appliance bulb.
6. Replace light shield.
7. Reconnect refrigerator to power supply.
To change the freezer light bulb:
1.
Disconnect refrigerator from power supply.
2. Push in sides of light shield until they snap free.
3. Replace with a 40-watt appliance bulb.
4. Snap light shield into place.
5. Reconnect refrigerator to power supply.
NOTE:
Not all commercial appliance bulbs will fit
your refrigerator. Be sure to replace a bulb with
one of the same size and shape.
Removing the base grille
To remove the grille:
1.
Open refrigerator door.
2. Pull base grille forward to release the
support tabs from the metal clips.
3.
Do not remove Tech Sheet
fastened
behind the grille.
To replace the grille:
Metal
clips
1.
Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close refrigerator door.
See cleaning instructions for defrost pan and
condenser coils on page 18.
Condenser coil.