Installation & System Operation
Figure 1-10
Rear Bottom Feet
Standoffs (x2)
Feet (x4)
3. Install the two rear locking feet from the (5023-0132) onto the analyzer,
Figure 1-11
Install Locking Feet on Network Analyzer
4. Remove the top two standoffs from the rear panel on the test set.
5. Install the two rear locking feet from the kit (U3021-60002) onto the test
Keysight N5261/62A User's & Service Guide
where the standoffs were removed.
set using two screws (0515-2317), included in shipment. Looking at the
rear panel, the N5242-20139 is the left foot and the N5242-20138 is the
right foot.
Locking Foot
from Kit
(5023-0132)
25