Keysight Technologies N5261A User's And Service Manual page 21

Installation & System Operation
Table 1-5 PNA-X Based Configurations (Continued)
PNA-X PNA
Model (s)
1
Option(s)
N5247A/B 200
200 & 224
400
400 & 423
1. All PNA-Xs require Option 020. When an N5262A is used with a 2-Port PNA-X, Option 551 is required. For B models, software option
S93898B is required.
2. Condition of the Route PNA RF to rear panel "RF OUT" check box. n = no, y = check, x = don't care. Refer to
3. See Rear Panel Figures 1-15
4. Can only drive output on one port at a time in this configuration.
5. Must use RF OUT on the rear panel.
6. Must use RF OUT or RF1 OUT on the rear panel. Options 224 and 423 do not provide rear panel
connections for Port 1. Functionality is the same as PNA-X without Option 224/423.
7. Must use RF1 OUT on the rear panel.
8. Must use RF OUT or RF2 OUT on the rear panel. Functionality is the same as PNA-X without Option 224/423.
Keysight N5261/62A User's & Service Guide
Test Set SRC
Connects
N5261A front
rear
N5262A front
rear
N5261A front
rear
N5262A front
rear
N5261A front
rear
N5262A front
rear
N5261A front
rear
N5262A front
rear
to 1-20 (A-F) and Front Panel Figures
Cable Interface
2
Ck
Kit
n N5261A-112
y N5261A-102
n N5262A-112
xxxx
n N5261A-112
y N5261A-102
n N5262A-112
y N5262A-104
n N5261A-114
y N5261A-102
n N5262A-114
y N5262A-104
n N5261A-114
y N5261A-104
n N5262A-114
y N5262A-104
1-21 to 1-22 (V-Z) for the configuration diagrams.
Conn. Capabilities and
Notes
3
Diag(s)
A Y [C1,C2,C3,C4__]
E
[C1,C2,C3,C4__]
B V
[C1,C2,C3,C4__]
xxxx config not available
A Y [C1,C2,C3,C4__]
E
[C1,C2,C3,C4,__]
B W [C1,C2,C3,C4__]
F [C1,C2,C3,C4,__]
A Z [C1,C2,C3,C4__]
E
[C1,C2,C3,C4,__]
B X [C1,C2,C3,C4,C5]
F [C1,C2,C3,C4,C5]
A Z [C1,C2,C3,C4__]
E
[C1,C2,C3,C4,__]
B X [C1,C2,C3,C4,C5]
F
[C1,C2,C3,C4,C5]
on
step 9 page 41.
5
4
6
7
6
8
15