Ingersoll-Rand 88H Series Maintenance Information
  1. Manuals
  2. Brands
  3. Ingersoll-Rand Manuals
  4. Grinder
  5. 88H Series
  6. Maintenance information
Ingersoll-Rand 88H Series Maintenance Information

Ingersoll-Rand 88H Series Maintenance Information

Air grinder
Hide thumbs Also See for 88H Series:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

16573347
Edition 2
February 2014
Air Grinder
Series 88H
Maintenance Information
Save These Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 88H Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Ingersoll-Rand 88H Series

Summary of Contents for Ingersoll-Rand 88H Series

  • Page 1 16573347 Edition 2 February 2014 Air Grinder Series 88H Maintenance Information Save These Instructions...

  • Page 2: Product Safety Information

    Product Safety Information WARNING • Failure to observe the following warnings, and to avoid these potentially hazardous situations, could result in death or serious injury. • Read and understand this and all other supplied manuals before installing, operating, repairing, maintaining, changing accessories on, or working near this product.
  • Page 3 Disassembly of the Arbor CAUTION Grasp the Arbor Housing (29) in a vise, guard upward. For Type 1 Wheels (Models 88HG60H106 and 88HL60H106), Use only the special 88V60-950 Controller Wrench for removing use an appropriate spanner wrench inserted into the pinhole of the Controller Assembly.
  • Page 4 For Grip Handle Models 8. Slip the Controller Assembly over the Rotor Shaft. Rotate the Controller counterclockwise since this is a left-hand thread. CAUTION Use only the special No. 88V60-950 Controller Wrench for applying the assembly. WARNING Tighten the Controller to 14 to 16 ft-lb (19.0 to 21.7 Nm) torque. Do not exceed 16 ft-lb.
  • Page 5 For Type 1 Wheels, place the Wheel Guard (54) onto the Arbor 11. For Cone Wheel (Model 88HL90L10), thread the Bearing Cap Housing (29), making sure the holes are aligned. Install the Guard on the Arbor Housing and tighten to 40 to 45 ft-lb (54 to 61 Nm) Screw Lock Washers (53) and Guard Screws (55).

  • Page 6: Troubleshooting Guide

    Troubleshooting Guide Trouble Probable Cause Solution Low power or low free speed Low air pressure at the Inlet Check the air pressure at the Inlet. For maximum performance and durability of parts, the pressure must not exceed 90 psig (6.2 bar/620 kPa). Plugged Screens Clean the Screens in a clean, suitable cleaning solution in a well ventilated area.
  • Page 7 Notes...
  • Page 8 ingersollrandproducts.com © 2014 Ingersoll Rand...

This manual is also suitable for:

88h6088h90

Table of Contents