Cooper Fail-Safe HDF LED Installation Instructions Manual

IB519082EN
Installation Instructions – HDF LED
Instructions d'installation – HDF LED
Instrucciones de instalación – HDF LED
WARNING
Make certain power is OFF before starting installation
or attempting any maintenance. Risk of Fire/Electric
Shock. If not qualified, consult an electrician.
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
GENERAL: Upon receipt of fixture thoroughly inspect for any freight damage, which should be brought to the attention
of the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label on the housing to
assure you have received the correct merchandise.
SAFETY: This fixture must be wired in accordance with the National Electrical Code and applicable local codes and
ordinances. Proper grounding is required to insure personal safety. Carefully observe grounding procedure under
installation section.
Do not mount near gas or electric heaters.
Equipment should be mounted at locations at a height where it is not readily subjected to tampering by unauthorized
personnel.
CLEANING:
The reflector and lens may be cleaned with any non-abrasive cloth and mild detergent (i.e. 409 Cleaner). Cleaning should
be done on the lens at room temperature, and out of direct sunlight. To remove paint, lipstick, marker, etc., the following
solvents may be used:
RECOMMENDED:
A solution of three (3) parts alcohol, one (1) part TOLUOL.
OR
Four (4) parts alcohol, one (1) part Methylethylketone MEK). Also safe, but less effective: Naphtha, Butyl Celiosolve,
Kerosene.
Risk of Electric Shock – Disconnect power at fuse or
● ●
circuit breaker before installing or servicing.
Risk of Burn – Disconnect power and allow fixture to
● ●
Cool before servicing.
Risk of Personal Injury – Fixture may become
● ●
damaged and/or unstable if not installed properly.
Brand Logo
reversed out of
black
INS # INS #