Control Panel; How To Navigate; Main Menu; Smig Mode: Basic - ESAB EMP 285ic 1ph Instruction Manual

6 CONTROL PANEL

6 CONTROL PANEL
General safety regulations for handling the equipment can be found in the "Safety
precautions" section in the "SAFETY" chapter of this manual. General information
about operation can be found in the "OPERATION" chapter of this manual. Read both
chapters thoroughly before you start using the equipment!
NOTE!
After power-on has completed the main menu appears on the control panel.
6.1

How to navigate

6.2

Main menu

6.3

sMIG mode: Basic

0463 618 001
1. Upper control knob
a) Set current output value
b) Set wire-feed speed
2. Lower control knob
a) MIG Voltage Selection
b) sMIG Voltage Trim
c) MMA Mode: ARC
ON/OFF
3. Menu navigation: Push to select
1. sMIG mode
2. Manual MIG mode
3. Flux-cored wire mode
4. MMA mode
5. Lift-TIG mode
6. Settings
7. User manual
8. Dialogue box
1. Home screen
2. Information
3. Memory
4. Material selection
5. Wire-feed speed selection
6. Material thickness indicator
7. Dialogue box
- 53 - © ESAB AB 2019