Introduction - Wesemann SYSTEM DELTA 30 User Manual

8
User Manual | Laboratory Fume Cupboard | Introduction

Introduction

1.1 Preamble
Our fume cupboards (as under 1.2) are tested and certified in accordance with DIN EN 14175. All persons
involved in the installation, maintenance and operation of the laboratory fume cupboards must be suitably
qualified. For installation and dismantling instructions, as well as information regarding disposal, please see the
separate assembly instructions for laboratory fume cupboards. Please read this user manual carefully before
operating the fume cupboard and observe all regulations and instructions.
Keep these instructions in a safe place for further use.
In the event of a sale of the laboratory fume cupboard, this manual must also handed over to the buyer.
Wesemann GmbH does not accept liability for damage caused by non-observance of the user manual.
1.2 Product variants
These instructions apply to the following products:
• DS-DG03-XXXX
• DS-DG03-XXXX-P
• DS-DG03-XXXX-1070
• DSN-DG03-XXXX
• DSN-DG03-XXXX-P
• DT-DG03-XXXX
• DT-DG03-XXXX-P
• DT-DG03-XXXX-1070
• DB-DG03-XXXX
• DB-DG03-XXXX-1070
• DB-DG03-XXXX-1270
The XXXX serve as placeholders for the respective grid 1200-2100.
In this manual, the generic term laboratory fume cupboard is used for the different variants.
1.3 Other applicable documents
The following documents for operating the fume cupboard are to be studied carefully:
• Operating instructions for accessory parts
• Safety Data Sheets
Table fume cupboard
Table fume cupboard DELTAprotect
Table fume cupboard, in special depth
Fume cupboard for low ceilings/spaces
Fume cupboard for low ceilings/spaces DELTAprotect
Low work-level fume cupboard
Low work-level fume cupboard DELTAprotect
Low work-level fume cupboard, in special depth
Walk-in fume cupboard
Walk-in fume cupboard in special depth
Walk-in fume cupboard in special depth