Furuno Inmarsat FleetBroadband FELCOM251 Installation Manual page 26

2.3.3 Coaxial cables
Attach coaxial connectors to the antenna cable as follows.
How to attach 8D-FB-CV coaxial connectors
Attach the coaxial plug (supplied) to the coaxial cable as follows. Your system has ei-
ther N-P-8DFB-1-CF or N-P-8DSFA connectors included.
• For N-P-8DFB-1-CF connectors
Outer Sheath
Armor
Cover with heat-shrink tubing and heat.
30
Clamp Nut
Gasket (reddish brown)
Clamp Nut
Dimensions in millimeters.
Inner Sheath Shield
50 30
10
U-shaped groove
Clamp
Aluminum Foil
Trim shield here.
Insulator
Trim alminum tape foil here.
5
Pin
Shell
Solder through the hole.
2. INSTALLING THE SYSTEM
Remove outer sheath and armor by the
dimensions shown left.
Expose inner sheath and shield by the dimen-
sions shown left.
Remove insulator and core by 10 mm.
Twist shield end.
Slip on clamp nut, gasket and clamp as shown
left.
Fold back shield over clamp and trim.
Cut alminum foil at four places, 90° from one
another.
Fold back alminum tape foil onto shield and
trim.
Expose the insulator by 1 mm.
Expose the core by 5 mm.
Slip the pin onto the conductor. Solder them
together through the hole on the pin.
Insert the pin into the shell. Screw the clamp
nut into the shell.
(Tighten by turning the clamp nut. Do not
tighten by turning the shell.)
2-13